Live data from Hacker News

Wasp Blower

softsolder.com

11–20 of 103 posts

Re: Wasp Blower

#11
post #8

For people that don’t know, regular wasps always leave in the face of danger to the nest. If you have the typical small nest, the easiest thing you can do is hit it fast with a broom or similar. They will all disappear in seconds. I’ve seen my dad do it a lot of times with his bare hands, never got stung. But if you pass by the nest enough times, you’ll be. Another good solution is fire. A blow torch with a wide flam…

lol. I had a neighbor burn his shed down that way. The fun (not sarcastic) of rural life.

Well, yeah. You have to be careful. Here, houses are made of brick, and almost no one has a shed, YMMV.

Re: Wasp Blower

#12
Vigilance and attentiveness is definitely better here; early in the year you are looking for a handful of wasps spending more time near any one part of the facade of your house than normal. Pick a warm day in mid-spring, go round the property and note where wasps are going.

You can safely use a spray to pick them off late in the evening, and if you get there early enough, depending on the species, one of those wasps could actually be the queen, because she may still be leaving the nest in order to care for her earliest brood.

If you don't get the queen, because the nest is so small, you may get enough toxin onto one of the early workers that they will bring it into contact with the queen.

You then use an insecticide foam around the entrance to any hole you see wasps going into. You can lay it on pretty thick, more than once, and they will progressively poison the nest. You can do this a few days apart in the evening.

Since the nest is still small you probably don't need to hit the nest, and you might as well leave it because then no other colony will use the space. You do need to saturate any pathway they take to it.

Directly above a bedroom window that is impossible to see from the outside but can be deduced by a process of elimination, in the roof of my 210 year old house, is a tiny gap, which attracted a nest nine years ago. I used this method and while I think I might very well have got the queen directtly, activity around the nest stopped in about 48 hours, and while every year I see wasps investigate the hole, I am guessing corpses put them off.

In the warm late spring of the pandemic I resprayed the hole, and sprayed a couple more, with what was left of the can, because I reasoned that it might be difficult to get a pest controller to deal with them; this proved to be a wise decision because nests established in several places nearby in that lovely hot summer that went untreated for far too long.

Re: Wasp Blower

#13

We had a wasps nest last summer inside the wall under the eaves of our house, some kid from the exterminator's came with a long telescoping rod and puffed some kind of white powder into the opening. He explained that it was something like a slow-acting poison (or maybe like diatomaceous earth) that would cover the drones when they left or arrived at the nest and that it was enough for one of these drones to brush up…

A good spray picking off the very earliest dozen or so wasps in the early spring may actually directly get the queen, who has not always permanently settled in. That point or the next few weeks is an excellent opportunity to add secondary toxins that the workers will carry in, because the nest is so small they will encounter the queen.

Beyond that I guess only completely saturating an internal trunk route through the thing with a tool like that is going to work!

Re: Wasp Blower

#14
I wish I had the was blower 3 months ago. Wasps nested in the space between my laundry room and the 2nd floor. The exit was a crack between the concrete blocks outside wall and the vinyl siding. They found an entrance into the house through the overhead light socket when a fool whose name shall not be mentioned duck-taped their regular exit route. A call to the pest-control and $400.00 USD later took care of it. They bore a tiny hole next to the exit and pumped lethal gas in it. The problem with the was blower in my case it it would have to be 8 ft attached to the wall.

Re: Wasp Blower

#15
I had two yellowjacket nests in the wood siding of my house this summer. Several cans of foaming spray had no effect since it couldn't penetrate far enough inside. I found a random forum thread where someone suggested using Sevin insecticide powder on the openings. It took a week and a half of daily applications using a paintbrush, but it seemed to be effective. Less expensive than calling an exterminator, and I have most of the can of powder left for next time.

Re: Wasp Blower

#16
I tend to use a shop vacuum to get rid of undesirable wasp nests. Fill the tank with a few litres of water so the victims have something to drown in, point the tube at the nest entry or whatever entry the wasps use and switch it on for an hour or so. As soon as there is some disturbance most of the resident wasps will exit the nest to defend it so you'll get the resident population in only a few minutes. Keep the vacuum in place for a while to catch those which were out and about. Once you've got (most of) the workers the nest will die out if left alone. If you can reach it you can knock it down and drown or burn it, if it is in a wall somewhere that is not an option.

Don't forget to put water in the tank or you'll be met by a cloud of angry wasps when you open it.

Re: Wasp Blower

#17

I had two yellowjacket nests in the wood siding of my house this summer. Several cans of foaming spray had no effect since it couldn't penetrate far enough inside. I found a random forum thread where someone suggested using Sevin insecticide powder on the openings. It took a week and a half of daily applications using a paintbrush, but it seemed to be effective. Less expensive than calling an exterminator, and I have…

Pro tip if you're trying to deal with any of these: Do it while it's cold. Do not (as I did the first time) gird your appendages in towels and other random shielding, then do it in the mid-afternoon when it's been warm for hours and they're prepped to go like fighter jets with warmed up engines. Get up first thing in the morning when it's crispy and you can just get a can of bug spray and coat each one as it comes out. Ethical? No. Effective? Yes. I believe those two might be at odds.

Re: Wasp Blower

#18
Unrelated to wasp eradication, but interesting, still:

Three Valuable Peptides from Bee and Wasp Venoms for Therapeutic and Biotechnological Use: Melittin, Apamin and Mastoparan [1]

BBC: Wasp venom 'a weapon against cancer' (2015) [2]

[1]: https://pmc.ncbi.nlm.nih.gov/articles/PMC8000949/

[2]: https://www.bbc.com/news/health-34115112

Re: Wasp Blower

#19
Similar story, had a nest in the walls of a bay window bump. Too far up the side to spray effectively, but they had one weakness: there was a clear entrance spot. So I duct taped a pool vacuum hose next to it and ran it into the garage attached to a shop vac. Left it running for a day, problem solved. It was fun listening to the "ka-thunk" sound when each insect got sucked in. I think for next time I'll make some kind of detector based on audio to count the kills.

Re: Wasp Blower

#20

I tend to use a shop vacuum to get rid of undesirable wasp nests. Fill the tank with a few litres of water so the victims have something to drown in, point the tube at the nest entry or whatever entry the wasps use and switch it on for an hour or so. As soon as there is some disturbance most of the resident wasps will exit the nest to defend it so you'll get the resident population in only a few minutes. Keep the vac…

If you forget the water at first, you can always vacuum it in later
Post reply on HN