Live data from Hacker News

Bus Pirate 5 Firmware

firmware.buspirate.com

1–10 of 38 posts

Re: Bus Pirate 5 Firmware

#6
post #5

For those who are new to it, and somewhat confused: https://hardware.buspirate.com/introduction

I am still confused. What is a typical use case?

This page gives a better introduction: http://dangerousprototypes.com/docs/Bus_Pirate

Basically a tool to interface with whatever IC you might have. Flexible input supporting many protocols, just hook it up to a random chip or serial debug pins on a board you are reverse-engineering and you can figure out the signal mapping and protocol decoding in software.

Re: Bus Pirate 5 Firmware

#7
post #5

For those who are new to it, and somewhat confused: https://hardware.buspirate.com/introduction

I am still confused. What is a typical use case?

It can be used as a TTL serial adapter (ex getting a command line on common hardware/IoT devices), JTAG (debug, dump firmware), reading flash memory chips, etc

Re: Bus Pirate 5 Firmware

#8
[tangental] two accounts created 3 days ago stating how wonderful the bus pirate is?

Cmon, surely you know better than this. And the BP is a great tool, it doesn’t need painfully obvious astroturfing

Re: Bus Pirate 5 Firmware

#10
post #8

[tangental] two accounts created 3 days ago stating how wonderful the bus pirate is? Cmon, surely you know better than this. And the BP is a great tool, it doesn’t need painfully obvious astroturfing

Uh? Not sure if you meant me (I submitted this instance) but my account is slightly older. I feel like a low-key but established member of this here bunch o' geeks.
Post reply on HN