This reminds me of a staple of my Boy Scout cooking: eggs in a bag. Just crack your eggs into a zip top bag (it must be a freezer bag to handle the temperature), add cheese, or peppers, or whatever you like in an omelet, suck out the air, and put it in boiling water until it’s done. Then, if you eat your omelet straight out of the bag, you have no clean up! It had never occurred to me then to try to cook anything els…
Just remember that there's a huge difference between boiling and SV'ing eggs. Boiled eggs sound gross. Boiled steak is gross. You don't want to let the eggs get over 150. Eggs cook fast . Water boils at 212f.
Cook Your Meat in a Beer Cooler: The World's Best Sous-Vide Hack
21–30 of 49 posts
Re: Cook Your Meat in a Beer Cooler: The World's Best Sous-Vide Hack
#22I would be at least a little worried about food poisoning. Cooking salmon at 115 deg F, or beef at 125 deg F or even chicken at 140 deg F is not a high enough temperature to kill off many harmful bacteria and parasites. In normal cooking, the external surfaces of the meat, where most contamination occurs, reach much higher temperatures.
Re: Cook Your Meat in a Beer Cooler: The World's Best Sous-Vide Hack
#23I have made a modified sous-vide setup based on the following excellent instructions which I have not seen mentioned here. Total cost was under $75 for me since I simplified the setup a bit. Temperature accuracy is excellent. http://seattlefoodgeek.com/2010/02/diy-sous-vide-heating-imm... Quick overview of my modifications. I used a 6" deep full size hotel pan I got in chinatown as my water bath and a standard $9 150…
That is awesome . How hard was it to make? When you switched to the 1500 watt heater, did you have to tinker much with the PID controller?
Oh, and the Radio Shack relay mentioned didn't work for me when hooked up to my PID's solid state relay (different PID then used in the link). The switching voltage wasn't enough but eventually got a relay that only needed 5V to switch. Short term I used the internal relay which worked fine, but was noisy and I wasn't comfortable driving that amount of amperage through it.
Re: Cook Your Meat in a Beer Cooler: The World's Best Sous-Vide Hack
#24I would be at least a little worried about food poisoning. Cooking salmon at 115 deg F, or beef at 125 deg F or even chicken at 140 deg F is not a high enough temperature to kill off many harmful bacteria and parasites. In normal cooking, the external surfaces of the meat, where most contamination occurs, reach much higher temperatures.
Killing most bacteria is a function of temperature and time. The higher the heat, the less time it has to be at that temperature. The lower the heat, the longer it has to be at that temperature. It's all a numbers game. Nothing is completely safe.
Nothing is completely safe, but food poisoning is also not fun.
Re: Cook Your Meat in a Beer Cooler: The World's Best Sous-Vide Hack
#25I would be at least a little worried about food poisoning. Cooking salmon at 115 deg F, or beef at 125 deg F or even chicken at 140 deg F is not a high enough temperature to kill off many harmful bacteria and parasites. In normal cooking, the external surfaces of the meat, where most contamination occurs, reach much higher temperatures.
The bigger risk is the time that the food is left in the danger zone of above 50 degrees and below 125 degrees (don't quote me on those numbers, going off memory). Basically any bacteria present in food in that temp range will start reproducing quickly. I have heard 4 hours as the time limit acceptable to have food in that temp range before being considered unsafe.
Re: Cook Your Meat in a Beer Cooler: The World's Best Sous-Vide Hack
#26Earlier quoted context omitted.
Killing most bacteria is a function of temperature and time. The higher the heat, the less time it has to be at that temperature. The lower the heat, the longer it has to be at that temperature. It's all a numbers game. Nothing is completely safe.
That's not entirely true. If you for instance "cook" meat at 100 degrees you'd end up with more bacteria than you started with. You do need to cook at a temperature that is hot enough to actually kill the bacteria. It's not a numbers game at all, it's understanding a little microbiology. Nothing is completely safe, but food poisoning is also not fun.
Re: Cook Your Meat in a Beer Cooler: The World's Best Sous-Vide Hack
#27Earlier quoted context omitted.
Killing most bacteria is a function of temperature and time. The higher the heat, the less time it has to be at that temperature. The lower the heat, the longer it has to be at that temperature. It's all a numbers game. Nothing is completely safe.
That's not entirely true. If you for instance "cook" meat at 100 degrees you'd end up with more bacteria than you started with. You do need to cook at a temperature that is hot enough to actually kill the bacteria. It's not a numbers game at all, it's understanding a little microbiology. Nothing is completely safe, but food poisoning is also not fun.
Re: Cook Your Meat in a Beer Cooler: The World's Best Sous-Vide Hack
#28I have made a modified sous-vide setup based on the following excellent instructions which I have not seen mentioned here. Total cost was under $75 for me since I simplified the setup a bit. Temperature accuracy is excellent. http://seattlefoodgeek.com/2010/02/diy-sous-vide-heating-imm... Quick overview of my modifications. I used a 6" deep full size hotel pan I got in chinatown as my water bath and a standard $9 150…
Re: Cook Your Meat in a Beer Cooler: The World's Best Sous-Vide Hack
#29Earlier quoted context omitted.
That is awesome . How hard was it to make? When you switched to the 1500 watt heater, did you have to tinker much with the PID controller?
Pretty easy once I got all the parts together. Assembled it all over the course of one night. Hardest part was drilling the hole into the side of the hotel pan for the water heater. Luckily my neighbor is an electrician and had a step bit that worked perfectly, took about 45 minutes. Oh, and the Radio Shack relay mentioned didn't work for me when hooked up to my PID's solid state relay (different PID then used in the…