50nm accuracy 3D printed Micro-Manipulator open source [video]
1–4 of 4 posts
Re: 50nm accuracy 3D printed Micro-Manipulator open source [video]
#2A prototype of a micro manipulator that achieves accuracy smaller than a human hair! Using only clever stepper driver, careful selection of motor encoder, and so much more!
Enjoy
Re: 50nm accuracy 3D printed Micro-Manipulator open source [video]
#3this is incredible. i was super skeptical about the limiting factor being the 3D printed parts, glue, and rubber bands, but he addresses that in the very end :)
Re: 50nm accuracy 3D printed Micro-Manipulator open source [video]
#4this is incredible. i was super skeptical about the limiting factor being the 3D printed parts, glue, and rubber bands, but he addresses that in the very end :)
Same!
Kind of goes to show if you optimize every parameter what the kind of crazy accuracy you can get