Print an Arduino-Powered Color Mechanical Television
spectrum.ieee.org
Print an Arduino-Powered Color Mechanical Television
1–6 of 6 posts
Re: Print an Arduino-Powered Color Mechanical Television
#2That’s cool. There is a nice demo at the start of this video https://youtu.be/LmISP_fAAws
Re: Print an Arduino-Powered Color Mechanical Television
#3Re: Print an Arduino-Powered Color Mechanical Television
#4Any reason a belt with holes couldn't replace the disk with holes for a more compact and rectangular viewing surface? Should be easy enough to test with a belt sander.
The closest thing from the time was mirror drums but those don't sound too similar, and they had mirrors for some reason.
Re: Print an Arduino-Powered Color Mechanical Television
#5Any reason a belt with holes couldn't replace the disk with holes for a more compact and rectangular viewing surface? Should be easy enough to test with a belt sander. The closest thing from the time was mirror drums but those don't sound too similar, and they had mirrors for some reason.
No reason I can see except a high-speed belt is substantially more mechanically complex than a spinning disk. But the funny shape is part of the charm imo.
Re: Print an Arduino-Powered Color Mechanical Television
#6Any reason a belt with holes couldn't replace the disk with holes for a more compact and rectangular viewing surface? Should be easy enough to test with a belt sander. The closest thing from the time was mirror drums but those don't sound too similar, and they had mirrors for some reason.
I think that the issue is that the display relies on persistence of vision and it might be a little difficult to find the correct spacing and setup to properly replicate the effect.
It would be worth looking into for a project though!