Why didn't the upgrade take over my OpenVPN packages? I had to install the packages openvpn and luci-app-openvpn manually, but the settings were still there, fortunately.
Stock firmwares do not include a big package like OpenVPN. Hence, it muat be redownloaded.
Stupid question:
Will doing a “opkg upgrade” give the same effective result as flashing an updated stock/sysupgrade image?
Asking because it’s annoying remembering which packages I need to reinstall.
Let me grab this occassion: is there a Elecom WRH-583BK2-S sized similarly dual RJ45 dual band router -- with OpenWRT compatibility? https://twitter.com/ysks/status/773135671057784833/photo/1 it is not OpenWRT compatible. Specs at https://twitter.com/ysks/status/773141289197981696
Look up gl.inet units. For example the GL-iNet 6416.
Need a quick primer on the differences between various current flavors of open router firmware.
DD-Wrt and Tomato are more specialized and both follow a strange and obtuse development process (hope you like reading neverending and always out of date forum threads). OpenWRT uses a more typical open source process with heavy utilization of GitHub. It's much easier to follow and participate.
As far as I am concerned, the OpenWRT community is the only one that has it's shit together.
Stock firmwares do not include a big package like OpenVPN. Hence, it muat be redownloaded.
Stupid question: Will doing a “opkg upgrade” give the same effective result as flashing an updated stock/sysupgrade image? Asking because it’s annoying remembering which packages I need to reinstall.
Let me grab this occassion: is there a Elecom WRH-583BK2-S sized similarly dual RJ45 dual band router -- with OpenWRT compatibility? https://twitter.com/ysks/status/773135671057784833/photo/1 it is not OpenWRT compatible. Specs at https://twitter.com/ysks/status/773141289197981696
The GL.iNet GL-AR750 is a bit bigger at 88x68x24mm @ 66g vs 65x35x20.5mm @ 45g but does have OpenWRT preinstalled.
This week due a wifi network intrusion I bought a Linksys Wrt3200acm. It looks good on paper and it has two boot partitions so it doesn't brick. I installed a device specific distribution recommended on the forums. Well, the 5ghz wifi range is total crap with Openwrt because the wifi driver is not as advanced as the one shipped by default and with the open source driver it can't transmit at full power. I ditched Open…
I would recommend a Ubiquti UniFi [1]. Although I'm so pissed off that I can't deeplink to their UniFi product page that I'm almost not making this very post. Which specific one depends on your needs and budget. [1] https://www.ui.com/products/#
I was a Wisp user for some time so I know the brand and it was a solid device overall. I looked into the UniFi products and the AP plus a controller is almost 100 euros more expensive than the Linksys device. I will look in the future for Ubiquiti devices but I think I am going to use a standard WiFi device (after all it is a one story flat not too big) and perhaps in the future I will buy a barebones so I can run pfsense with the current wifi device as a dumb AP.
I run OpenWrt on my wrt3200acm. It runs grate, but I use it for routing only. I run 2 TP-Link c7 v2s as dumb APs for both 5 and 2.4 GHZ. The c7s are on OpenWrt to. The WRT3200acm does adblocking, runs BanIP and DNS over HTTPS. Plus some firewall rools and BCP38. I am very happy with OpenWrt and my setup! If you have a router that can run OpenWrt you should giv it a go. We have good forums and a irc channel. Even a twitter to help.
https://twitter.com/openwrth?lang=en
Happy flashing!
This week due a wifi network intrusion I bought a Linksys Wrt3200acm. It looks good on paper and it has two boot partitions so it doesn't brick. I installed a device specific distribution recommended on the forums. Well, the 5ghz wifi range is total crap with Openwrt because the wifi driver is not as advanced as the one shipped by default and with the open source driver it can't transmit at full power. I ditched Open…
Ubiquiti. Check out the UniFi Dream Machine for all in one. It’s early access right now.
Need a quick primer on the differences between various current flavors of open router firmware.
Tomato - Broadcom only - 2.6.22/.38 kernel (with multiple patches on top). DD-WRT - Most compatible - various kernels - some drivers are closed source OpenWrt - Fully open (except for firmware) - Latest LTS kernels. 19.07 will use 4.14 for almost every target.
I would recommend a Ubiquti UniFi [1]. Although I'm so pissed off that I can't deeplink to their UniFi product page that I'm almost not making this very post. Which specific one depends on your needs and budget. [1] https://www.ui.com/products/#
I was a Wisp user for some time so I know the brand and it was a solid device overall. I looked into the UniFi products and the AP plus a controller is almost 100 euros more expensive than the Linksys device. I will look in the future for Ubiquiti devices but I think I am going to use a standard WiFi device (after all it is a one story flat not too big) and perhaps in the future I will buy a barebones so I can run pf…
You can run controller in the cloud, or on a Raspberry Pi, or on a VM, or ...