Show HN: Prototyping board for making motion sensitive wearable light
1–3 of 3 posts
Re: Show HN: Prototyping board for making motion sensitive wearable light
#2Hi there! I made this, it turn electro-luminescent materials (the make EL wire, EL panels/tape, EL paint) into a capacitive touch sensor
It is also an open source arduino compatible board based on the ATMEGA 32u4, so it is programmable using a micro USB cable, and can use it's port to output keyboard and mouse commands.
Re: Show HN: Prototyping board for making motion sensitive wearable light
#3Hi there! I made this, it turn electro-luminescent materials (the make EL wire, EL panels/tape, EL paint) into a capacitive touch sensor It is also an open source arduino compatible board based on the ATMEGA 32u4, so it is programmable using a micro USB cable, and can use it's port to output keyboard and mouse commands.
It can also be connected to wireless chips, like the NRF24, XBEE, or the ESP6822 wifi module to have installations or garments that are networked with each other.